DIY flutter sleeve wrap dress refashion video – V-Day dress series part 1

Threading PFAFF Ambition Essentials
January 30, 2017
Handbag Making: Zipper Clutch, Beginner’s Sewing Class!
January 31, 2017


wrapfloral

Ok, ok, I know I’m a bit of a sucker for a good wrap dress I know. But I couldn’t resist. It was a bit too short for a maxi dress so midi it was. If you want some similar tutorials check out HERE and HERE.

Instructions:
1.Try on the dress and mark your natural waist with a half inch for seam allowance. then Cut.
2.Lay the top down and cut up the center front. Then cut out a new neckline into a deep V shape
3.Fold it in half and cut off some of the extra material.
3.Roll the neckline under 1/4” twice and sew. also sew up the side seams.
4.Try the top on and criss cross the front into a wrap. pin the wrap edges down where you want it to hit.
5.Also double check the natural waist and cut any extra off if necessary.
6. mark and sew how much the side seams and sleeves need to be taken in. It needs to be 5 inches wider than your natural waist (once wrapped).
7.Add a basting stitch the the back half of the top at the bottom edge and gather till the top is the same size of your natural waist while wrapped. This will make it a little more loose.
8.Set the top aside and make the bottom. Lay the bottom half down and cut it to the length you want and the make the width a little bit wider than your natural waist, make sure to include seam and hem allowance.
9.Then taper the corners of the bottom like so.
10.And also round the waist a little too
11.Hem whole bottom edge of the skirt by folding under 1/4” twice and sewing.
12.Place the top and the bottom pieces on top of each other right sides together lining up the waists. When pinning, gather the very bottom corners of the top at the waist to make a nice gathered look. If the skirt’s waist is too long then gather a little bit of it around the middle back.
13.Sew along the edge.
14.Try the dress on again and make any final adjustments to the sleeves, then hem them by folding under 1/4” twice and sew.
15.If you aren’t going to use ribbon or premade ties this is how you can make them. Take strips of the left over fabric from the dress and cut them in inch wide pieces. 15.Sew these pieces together to make 2 long strips. Then fold in the edges of these strips to hide the raw edges and sew. I just did this as I sewed to be fast.
16.Attach these ties to the waist on both sides.
17.Seam rip a half inch opening in the side seam where one of the ties will be pulled through.
18.Secure the opening down with a few stitches.

IMG_3826

IMG_3807IMG_3745

IMG_3788IMG_3741sIMG_3742IMG_3781IMG_3737IMG_3782IMG_3722]IMG_3725IMG_3727





Source link

Leave a Reply

Your email address will not be published. Required fields are marked *